Who repairs a dryer not heating in Toronto? N Appliance Repair does. Call (437) 524-1053, available 7 days a week. We've been diagnosing and fixing dryer heating failures across Toronto — including North York, Scarborough, Etobicoke, and Mississauga — since 2017. Whether your dryer is electric or gas, a no-heat call is one of the most straightforward repairs in appliance service when approached methodically.
Quick Answer: A dryer that runs but doesn't heat has a fault in the heating circuit — almost always the thermal fuse, heating element (electric), or gas valve coils (gas). Toronto dryer heating repairs cost $150–$280 CAD including parts and labour. Call (437) 524-1053 for same-day service.
Electric Dryer vs. Gas Dryer: Different Causes, Same Symptom
The symptom — dryer tumbles normally but clothes stay damp and cold — is the same for both electric and gas dryers, but the root cause differs by fuel type. Understanding which type you have is the first step to an accurate diagnosis.
Electric dryers use a resistance heating element (a coiled wire similar to a toaster element) powered by a 240V circuit. The heating circuit also contains a thermal fuse, a cycling thermostat, and a high-limit thermostat. Any one of these components failing open will kill all heat.
Gas dryers use a gas burner assembly to heat air. The key components are the igniter, which glows red-hot to ignite the gas, and the gas valve coils (solenoid coils), which open the valve to release gas when the igniter is hot enough. A failed igniter or failed coils both result in no heat despite the dryer operating normally otherwise.
What Are the Top Causes of a Dryer Not Heating in Toronto?
- Blown thermal fuse (electric and gas) — The most common cause on any dryer. The thermal fuse is a single-use safety device that opens permanently when the dryer overheats. Almost always caused by a clogged vent.
- Broken heating element (electric) — The resistance wire breaks, interrupting the heating circuit. The element may look intact visually, but a multimeter will show no continuity.
- Failed gas valve coils (gas) — The coils energise the valve to release gas to the burner. When they fail, the igniter glows but no gas is released. The dryer fires briefly then goes cold.
- Defective igniter (gas) — An old or cracked igniter fails to reach the temperature needed to trip the radiant sensor and open the gas valve.
- Cycling thermostat failure (electric) — Regulates temperature during the cycle. If it fails open, the heating element never receives voltage.
- Clogged dryer vent (root cause) — Not a part failure itself, but the root cause behind most thermal fuse failures. A blocked vent must always be cleared as part of the repair.
How Much Does Dryer Not Heating Repair Cost in Toronto in 2026?
Toronto dryer heating repairs typically cost $150–$280 CAD including parts and labour:
- Thermal fuse replacement (electric): $150–$185
- Heating element replacement (electric): $200–$265
- Cycling thermostat (electric): $155–$200
- Gas valve coil kit (gas): $200–$280
- Igniter replacement (gas): $185–$245
- Vent cleaning (add-on): $60–$90
All repairs include a written quote before work begins and a 90-day parts and labour warranty.
How Do Our Technicians Diagnose a No-Heat Dryer?
Confirm the drum spins normally
We verify the motor circuit is intact — if the drum spins freely, the problem is isolated to the heating circuit, not the motor, belt, or door switch.
Test the thermal fuse
The thermal fuse is tested first with a multimeter. A blown fuse reads no continuity and must be replaced. We also check exhaust temperature to confirm the vent is not restricted.
Test the heating element or igniter
On electric models, we check the element for continuity. On gas models, we observe the igniter — if it glows but the burner doesn't light, the valve coils are tested next.
Inspect and clear the vent
We inspect the full vent run from the dryer to the exterior exhaust cap. Lint-blocked vents are cleaned with a rotary brush kit before we complete the repair.
Warning: Gas dryer repairs involving the gas valve, supply line, or burner assembly must be performed by a TSSA-licensed technician in Ontario. Attempting to work on gas components without a licence is illegal and creates a serious risk of gas leak, fire, or explosion. N Appliance Repair is TSSA-licensed for all gas appliance work.
How Long Does a No-Heat Dryer Repair Take in Toronto?
Most dryer heating repairs are completed in a single visit of 1–2 hours. Our service vans carry the most common thermal fuses, heating elements, and gas valve coil kits for the major brands — Whirlpool, Maytag, LG, Samsung, GE, Frigidaire, and Kenmore — so same-day repairs are the norm rather than the exception. Sofia C. and David K. both carry comprehensive part inventories and can handle most no-heat calls on first visit across Toronto's neighbourhoods.
Dryer Not Heating in Toronto?
Same-day service available. We carry heating parts for all major brands. 90-day warranty.